Search

Structural Epoxy Adhesive

Structural Epoxy Adhesive

PRODUCT DESCRIPTION Thixotropic two part structural adhesive based on epoxy resin in a cartridge. USES As a structural adhesive for: ▪ Concrete elements ▪ Hard natural stone ▪ Ceramics, fibre cement ▪ Mortar, Bricks, Blocks, Masonry, render etc. ▪ Steel, Iron, Aluminium ▪ Wood ▪ Polyester, Epoxy......

Send InquiryChat Now

PRODUCT DESCRIPTION

Thixotropic two part structural adhesive based on epoxy resin in a cartridge.


structural-epoxy-adhesive33001116462


USES

As a structural adhesive for:

▪ Concrete elements

▪ Hard natural stone

▪ Ceramics, fibre cement

▪ Mortar, Bricks, Blocks, Masonry, render etc.

▪ Steel, Iron, Aluminium

▪ Wood

▪ Polyester, Epoxy


For concrete repairs Interior, vertical and overhead repair of:

▪ Corners and edges

▪ Hole and void filling

▪ Joint arrises


Joint filling and crack sealing:

▪ Crack filling and sealing (non-moving)


Metalwork, carpentry:

▪ Fixing and fastening of handrails, railings, balus- trades and supports

▪ Fixing of window and door frames


For use in the following:

▪ Concrete

▪ Hard natural stone

▪ Solid rock

▪ Hollow and solid masonry

▪ Steel

▪ Wood

 

CHARACTERISTICS / ADVANTAGES

▪ Can be used on damp concrete

▪ Excellent adhesion to the substrate

▪ Non-sag, also overhead

▪ High load capacity

▪ Shrinkage-free hardening

▪ Styrene-free


APPROVALS / STANDARDS

Testing according to EN 1504-4.

PRODUCT INFORMATION

11.jpg

33.jpg


SUBSTRATE QUALITY

Mortar and concrete must be older than 28 days. Adequate substrate strength (concrete, masonry, nat- ural stone) must always be confirmed.


MIXING

Getting the cartridge ready

▪ Unscrew and remove the cap

▪ Pull out the plug

▪ Screw on the static mixer

▪ Place the cartridge into the gun and start application

Important note: When the work is interrupted the static mixer can remain on the cartridge after the gun pressure has been relieved. If the resin has hardened in the nozzle when work is resumed, a new nozzle must be attached.


APPLICATION METHOD / TOOLS

General Advice:

▪ Clean the substrate (free from oil, grease and dust, no loose or friable particles, no cement laitance).

▪ Pump approx. twice until both components start to come out uniformly. Do not use this material. Re- lease the gun pressure and clean the end of the nozzle with a cloth.

▪ Apply the adhesive. Observe the open time.

▪ During curing / hardening the fixing must not be moved. Observe the curing time. Wash tools imme- diately with Tasir® Thinner C. Wash hands and skin thoroughly with warm soap water afterwards.


Concrete, natural stone, cement mortar and render:

Clean, free from oils and grease, no loose or friable particles, no cement laitance.

Age of concrete 3 to 6 weeks (dependent on mix design and environment).

Preparation: Blast cleaning or grinding.


Construction steel 37, V2 A steel:

Free from oil, grease, rust or mill scale. Preparation: Blast cleaning or grinding.

Avoid dew point conditions. If prepared steel is not to be used immediately, its surface must be coated with Tasir®-guard02 to protect it.


Polyester, epoxy, ceramics:

Free from oils and grease. Polyester epoxy: Grind, us- ing coarse abrasive.

Glass, ceramics: Grinding, do not apply to siliconised substrates.


CLEANING OF TOOLS

Clean all tools and application equipment with Tasir® Thinner C immediately after use. Hardened / curded material can only be mechanically removed.


LIMITATIONS

Tasir®-Epo resins are formulated to have low creep un- der permanent loading. However due to the creep be- haviour of all polymer materials under load, the long term structural design load must account for creep.

Generally the long term structural design load must be lower than 20-25% of the failure load. Please consult a structural engineer for load calculations for your spe- cific application.

 

VALUE BASE

All technical data stated in this Product Data Sheet are based on laboratory tests. Actual measured data may vary due to circumstances beyond our control.


LOCAL RESTRICTIONS

Please note that as a result of specific local regula- tions the performance of this product may vary from country to country. Please consult the local Product Data Sheet for the exact description of the application fields.


ECOLOGY, HEALTH AND SAFETY

For information and advice on the safe handling, stor- age and disposal of chemical products, users shall refer to the most recent Safety Data Sheet (SDS) containing physical, ecological, toxicological and other safety-re- lated data.


LEGAL NOTES

The information, and, in particular, the recommendations relating to the application and end-use of TASIR products, are given in good faith based on TASIR's current knowledge and experience of the products when properly stored, handled and applied under normal conditions in accordance with TASIR’s recommendations. In practice, the differences in materials, substrates and actual site conditions are such that no warranty in respect of merchantability or of fitness for a particular purpose, nor any liability arising out of any legal relationship whatsoever, can be inferred either from this information, or from any written recommendations, or from any other advice offered. The user of the product must test the product's suitability for the intended application and purpose. TASIR reserves the right to change the properties of its products. The proprietary rights of third parties must be observed. All orders are accepted subject to our current terms of sale and delivery. Users must always refer to the most recent issue of the local Product Data Sheet for the product concerned, copies of which will be supplied on request.


Tasir Construction Material&Technology  Corporate Headquarters

Tianda Block, Jianggan District, Hangzhou City, Zhejiang Province, China

Tel: +86-571-28119206 

Fax: +86-571-28197878

groutmaterial.com


Specifications Subject to Change.

For most current version of datasheet, go to groutmaterial.com

© 2018Tasir Construction Material&TechnologyCp.,Ltd | 08-21-2018 Rev. H | China Owned & Operated


Hot Tags: structural epoxy adhesive, China, suppliers, manufacturers, cheap, made in China
Related Products
Copyright © Zhejiang Taizheng Construction Material Co.,Ltd All Rights Reserved.